Contact Us

TEL : +86-512-88161587
Address: 10005 room, Zhongxiang Financial Building, Jiayuan Road, Xiangcheng District, Suzhou, China.

The Most Important Two Technical Factors In The Design Of Hot Runner
May 23, 2017

A successful hot Runner mold application project needs several links to be protected. The most important of these are two technical factors.

One is the control of plastic temperature and the other is the control of plastic flow. 1. The control of plastic temperature is very important in the application of the hot runner mold. Many production process and product quality problems come directly from the Hot runner system temperature control is not good. such as the use of hot needle gate method injection molding when the quality of the product gate problem, valve gate method forming when the valve pin closure difficult problem, multi-cavity mold parts Tim filling time and quality inconsistency. If possible, we should choose a hot runner system with different temperature control to increase the flexibility and adaptability.

Second, plastic flow control plastic in the hot runner system to flow balance. The gate should be opened at the same time to make the plastic synchronously filling the cavities. For the difference between the weight of the parts Familymold to the design of the runner size balance. Otherwise, there will be some parts filled with mold to protect the pressure is not enough, some parts are filled with excessive pressure, flying edge too large quality problems. It is reasonable to design the runner size. Size too small filling die pressure loss too large. The size is too large, the hot runner volume is too large, plastic in the hot runner system to stay for too long, damaged material properties and caused the parts to be unable to meet the requirements of the use