Contact Us

TEL : +86-512-88161587
E-mail: orando@kylinsz.com
Address: 10005 room, Zhongxiang Financial Building, Jiayuan Road, Xiangcheng District, Suzhou, China.

KT-300S 8 zones Hot Runner Plastic Injection Temperature Controller Compatible with DME, Yudo, Athena, Tinko

Hot Runner Plastic Injection Temperature Controller Compatible with Dme, Yudo, Athena, Tinko KT-300S Series hot runner temperature controller is single point control. The controller is assembled with single point temperature control cards. Each card only controls the temperature of one hot...

Hot Runner Plastic Injection Temperature Controller Compatible with Dme, Yudo, Athena

KT-300S Series hot runner temperature controller is single point control. The controller is assembled with single point temperature control cards. Each card only controls the temperature of one hot point. The display of control card can show preset temperature, actual temperature and alarm, and you may set temperature parameters via the display.

300S 8zones hot runner controller(001).jpg

8 zones

Features:
1. Inserted structure, easy to replace and repair.
2. Real time cool-end compensation, when turn on, display real temperature of the environment.
3. Accuracy: ±0.1℃
4. Heater and THERMOCOUPLE fault alarm
5. High voltage alarm
6. Three modes: automatic mode, manual mode and standby mode
7. Two output mode: PID and PIDD
8. Two types of THERMOCOUPLE: J and K
9. TRIAC and RALEY series connection, double protection.
10. Self testing when turn on.


图片1.jpg


Error code and solutions

Fault

Display

Solutions

Thermocouple breakage

tC oPEn display tC alternately with oPEn

Test the thermocouple with ohmmeter

Thermocouple pinched

tC SHrt display tC alternately with SHrt

Find where the thermocouple is pinched

Thermocpuple inverted

tC rEu display tC alternately with rEu

Check the thermocouple

Thermocouple and heater swapped

tC bAd display tC alternately with bAd

Check the thermocoule and heater

Scr breakage

Scr bAd display scr alternately with bAd

Test the Scr with ohmmeter

The voltage is error

HIGH voL display HIGH alternately with voL

Check the the input voltage in cabinet

Heater breakage

HEAt oPEn display HEAt alternately with oPEn

Test the heater with ohmmeter

Heater pinched

out SHrt display out alternately with SHrt

Find where the heater is pinched

Fuse breakage

F1-2 brk display F1or2 alternately with brk

Replace the fuse F1 or F2

Order please tell
1. circuit diagram(choose from A/B/C/D)

图片2.png


2. Wiring Diagram
5pins connector:

图片6.png

16pins connector:

图片7.png图片8.png

24pins connector:

图片9.png

Inquiry